OK, now I see what it is.. Still too expensive, though (IMHO)
Try here:
http://smartautomation.en.made-in-ch...nd-Driver.html
However, this guy has his own controller/driver - so the motor type and gearhead reduction ratio was not the problem for him.
Are you doing your own, or you are using the original controller? If you are just replacing the motors, they may not be suitable because of wrong reduction ratio.
Quote:
|
(24, Gear ratio 1/250 Sanryusha P43HG Steps).
Orientalmotor PK223PA-SG36 Steps 200, Gear ratio 1/36）
Therefore, we replaced the motor (200, Gear ratio 1/36 Orientalmotor PK223PA-SG36 Steps)
|
According to my understanding of the translated text, those two motors doesn't have the same ratio - first motor has 7000steps/rev total (with gearbox), the other one (orientalmotor) has 7200s/rev..
You will have to configure your control box somehow to fit the new gear ratio.