Quote:
Originally Posted by multiweb
Yeah , too low voltage will do that. Had the exact same problem. Even took the worm completely off the meshing and it would still stall. Just low voltage. That's all. 16V will fix it. If not then the motor has been damaged (likely overheating) and needs changing.
|
Jeez...I've felt the motor torque on the pinions (of a G1) with them driving @12V (normal rates)...damn...no way to even attempt to hold them. But with no load...I am surprised.
Lots have complained about Gemini @12V...I've personally never had an issue but that doesn't mean much.
What are the G2 drive H bridge drivers like? Maybe there is a change wrt this.
