|
Hi Peter
I haven't written a script for years so I had forgotten the calls. I will need to brush up on them.
When I wrote scripts previously I always "stored " the start configuration. That gave me an easy point to return to when the script was over. I did not do that with yours. I just set the rate, zoom and date to an arbitary figure close to the start so that I would know when the script was over.
In most of the other scripts I have you don't know when they actually stop so that you can reset your display.
Barry
Yes the lathe still works. It is in a bit of a mess at the moment as I haven't cleaned up after the last job.
|