back again, bit of a spell during the last post had to take a breather. Anyway further images:
1 - Four wheel running position, very stable and so easy to push.
2 - This is the wheelbarrow method and my ugly mug. If it is possible to imagine the ease of holding it, my fingers are loosely placed around the axle. This will also benefit the wedge because it is the rough position that the wedge will be when fully operational. I have good balance from about 20 - 70 deg incline. In any future builds or modifications, I may look closer at COG, but for the moment it was just a fluke.
3 - Very easy to roll it up onto the van ledge and as shown stay there, I have a slight incline in the driveway but not on the garage concrete. I will consider wheel chocks if I need to prevent the scope from rolling out, but is very stable and felt comfortable in leaving it to get the camera.
4 - Final position only just fits inside the van. Citreon Berlingo similar to the smaller VW, Renault and Holden Combo in size. If it was a problem I could remove the tube but glad I don't have to.
There are 3 primary tasks left to carry out, Motor drive RA only (making it very similar to a EQ Platform operatively), Feet for levelling (got that worked out but need certain type of feet) and forgot the last thing (age creping up
)
later all.