[vic4loc (Victor)]

Hi,

Thanks for the feedback. I'm still learning the LRGB processing techniques.

Originally Posted by rcheshire

Did you combine all the channels? I guess yes. Could it be calibration / white balance?

I have using only the tools in MaximLE. Have not played much with colour balance/adjustments. Basically these are the steps I did:

1. setup the calibration,
2. open the set of Red subs, then Calibrate All,
3. then Align and Combine them
4. perform Stretch
5. repeat process for Green & Blue
6. finally I do the Combine Colour, with all the default values

So far I noticed all my RGB image has a blue tinge to them. Is blue a lot more sensitive while imaging? I even compensate that by reducing it's sub exposures, but still seem to get a strong blue.

Originally Posted by bmitchell82

So make sure that you have actually set the right filters up eg. when you click blue filter its moves to the blue filter.

I'm quite sure I set all the filter and configured correctly to match in the software. I can check again tomorrow.

Thanks again,
Victor.