|
Just a bit of an update.
I checked the spring plungers and these were ok, but one was a little further in. I have now shifted that out just a little to suit the other plunger which is correct.
The alarms still went off last night, but today I rechecked balance. I was only very slightly out of balance (I do mean slight too) and I have found that I need to be more than 1/10 turn from tight on the balance knob. It is about 1 full turn and a bit. Even then the alarm goes off. Maybe time to check electronics.
PA is now near excellent. 15 seconds on MA 25 seconds on ME, close enough for me.
Point is good too, but could do with more points. I had some trouble last night with pin point solving. Odd behaviour.
Working through this slowly, but would like some advice on the mount alarm stuff. Peter can you help please?
|