Yeah was me posting on Bisque forum, not that i've had any response from the makers yet
It's set up for SH haven't tried to reset location as was ok before but can do, have even reset to defaults, loaded firmware and still the same .
So now i know this is not normal slewing, thanks for the replies.
Will reset location etc today try yet again lol.
Ok redid location to Perth australia time is same as comp clock and is out by like 0.5 sec when TheSkyX verifies, still does slewing behaviour and not reaches targer as well.
I don't know of anything that would make it do this ? Maybe i need a new board ?
Marcus.