Quote:
Originally Posted by netwolf
Peter, I dont have the cables need to get them. At present i am using Sitech system for my G11 and going to switch to Gemini from someone who has upgraded to Gemini2. But no cables. I think straight through should work, but i am not sure. The Losamandy diagram has only one diagram which i assume is the same for both Motor and controller if so a straight through should work.
Also anyone reccomend a 12v power supply that will handle the Gemini? My Jumpstart battery has kicked it in I think. Its not holding a charge anymore. Can still probably use it as a pass through, ie plug it to mains then power from the 12v outlet. Is 12v enough fro Gemini? How much current does it need?
Regards
Fahim
|
Fahim
What? You've given up on the SiTech already? Mine's working a treat now after a few issues (noob's disease!) were sorted out and I'm experimenting with PointXP and plate-solving this festive holdiays - the thing points accurately with just the single Offset Init for me on the same side of the meridian and when I switch over to the other side I just do one Offset Init again and good to go
Cheers
Bill