|
First off all, I should make it clear that it wasn't my hand controller moving the mount. I was winding the pulley using a allen key.
I'm guiding with a 60mm f/11.6 tasco refractor.
I would also say maybe 1-2mm as well. When calibrating in PhD, the mount only requires about 3 iterations to clear backlash.
I might have to take the mount apart again and start from scratch. I didn't make all the necessary measurements to determine correct shimming sizes. I just went with the ones that were already in there.
Last edited by swannies1983; 15-11-2011 at 06:10 PM.
|