|
Thanks everyone. Sure I will have more soon.
Looks like using bisque tcs for PEC is the go rather than pempro.
I notice north south orientation seems important to this. Does it matter if longer side of rectangular chip is in north south plane vs shorter side so long as either are parallel to north south and east west?
Also when setting limits can you set these on both sides. Ie set east limit after checking east radio button then update flash and then click set west and do the same. Or can you only se limit on one side ?
Be nice to be able to start an imaging run when an object is say 2 hours east of meridian and then have it track over into the west. Using the colored or shaded area in sky x should make this easy but will require limits set on both sides.
|