Quote:
Originally Posted by Marke
If I set it at -15c it may go to 0c for a min or 2 then down to -17c then in a few min settle at -15 give or take about 0.2c so as close as I can reasonably expect. I havent payed much attention to power draw just
that the temp was spot on as far as I was concerned and did it in a couple steps. Maybe try reinstalling the drivers again ?
|
Did that already and also tried two separate ascom platforms: 5.5 and 6.0. Same result in 3 softwares as well. Maximd DL 5.x, Nebulosity 2.x and EZcap supplied by supplier.
I restored the laptop back from a previous image without any drivers each time so I know it's not an old driver conflict. I suspect the DC-201 but without knowing more how it operates I can only speculate at this stage.
Otherwise I shot some darks and it seems ok. Just the TEC playing yoyo.