Quote:
Originally Posted by Marke
Marc I have a qhy10 with the glass front, not sure if yours is the same
but if it is then its N2 purged and sealed with a little screw on the side.
If moisture gets in there was a supplied desiccant chamber with mine
that goes on in place of this screw in order to remove moisture. Then you
put the screw back to seal it. The glass should be left on the front to seal it
and protect it from frosting.
|
The QHY10 is a different design again. There's a dessicant plug for the QHY9 too. I just want to know if it's ok to run the QHY9 with the main camera body to ambient air.