|
I just received my Catseye tools and am learning how to use them. A couple of suggestions:
Have you tried slightly rotating the secondary itself while viewing to see if this brings the reflections closer together? You may have to back off the secondary screws to allow this. I inserted a large diameter M5 washer sandwiched between two milk jug washers atop the secondary holder to make this easier to do without loosening the secondary collimation screws.
Have you checked that the focuser is square to the tube axis? I haven't figured out the best way to do this. Jim's explanation in the instructions using is a little hard to follow without any diagrams.
|