|
Thanks guys... Attached is a not so quick drawing of what I am thinking about to anchor the wires to the cage trusses. Basically, take a piece aluminum rod and drill it to accept the guitar wire. Drill and tap a hole to insert a set screw that will hold the wire in place. The drill and tap the end to insert a cap screw. The cap screw will not only hold the piece in place but also act as a way to tighten it up. I was thinking maybe I should insert a piece of dowel into the truss as a way to prevent the truss tube from compressing as the cap screw is tightened. That might be overkill because I don't think there will be that much pressure. Let me know what you guys think.
|