Quote:
Originally Posted by Moon
I also found it difficult to find pipe of the right dimensions. Most places are reluctant to buy an entire length for a small project like a pier and have the remaining piece sitting in their workshop after the job is done. My fabricator had some leftover 300x300 square section, the same that is used for road signs on freeways. It worked out well for me because it's the same size and shape as the base of the mount. Structurally there is no issue going with a square section - it doesn't have to be round.
James
|
Thanks James; I'm waiting on the fabricator getting back to me with what he can get but just in case, can you give me the details of your fabricator so I can source it from them or even get them to make it? Then I have to factor in the transport cost to 'sunny'? Qld. Also what was your design and for what type of scope (I have a CPC 1100). Thx, Peter