Photos below. They are of:
- The first one is of the outside of the case,
- The second shows how it all fits in there,
- The third is all included accessories (motofocus unit, motofocus controller, webcam and TV barlow and finder) - note I have not pictured the EP and diagonal, but just imagine entry-point quality for those two.
- The fourth is a close up of the OTA objective (a little dusty - I will give it a clean before it goes).
- The fifth is a close up of the barlow with small slots removed. The reason for this was I was cleaning the barlow objective when I dropped the barrel section of the barlow, denting the threaded part inwards in two places. I tried reshaping it with a rubber hammer and dowel, but it remained stubborn and I ended up just cutting out the pushed-in sections of the barrel.
I also seem to have neglected to say it has Bob's Knobs for easy collimation fitted as well.
Hope this helps.
