|
Hmmm, maybe compare that with a scope that is cooled with an SCT cooler. The trouble is where to put the sensors. You need to open up the back of the scope and attach the sensor to the mirror and another inside the tube. You would need to drill a hole in the rear or side of the scope for the sensor' wire to pass through and then leave enough play in the wire to travel, however not too much so that it gets tangled in the focus workings. Don't know about you but I don't want to go drilling holes in my scope until my warrantee runs out in two years.
Its a good idea, but fraught with lots of dangers in relation to SCT's especially when the mirror is moving.
|