Quote:
Originally Posted by ozstockman
I would be happy to make Carey masks especially if there is any interest in them. However as we discussed it with George on the 2nd page of this topic material used for them should be 1-1.5mm thick. So far I couldn't find anything not expensive and thinner than 1.5mm. I will check with my current acrylic supplier if they have any plastic that is 1-1.5mm thin.
|
Can you do cuts at an angle like this sectional view? It would get the thinner edge, but require two passes. Or does the mask require both corners to be at 90 deg?