Quote:
Originally Posted by bojan
I have couple of spare boards, processors.. (as shown on previously mentioned thread)
But first, you have to build the mount, with suitable stepper motor.. This will determine the rate for the stepper. The firmware must be compiled for each individual case.... Very easy to do but, considering the processors I am using are OTP (very old Motorola KJ705), the rate must be known in advance, because once programmed, processor can't be re-programmed again.
|
Based on the sizes in my link to the plans I'm using, how could I determine a suitable stepper motor (specs etc)? I think it's time I put together a shopping list
