Quote:
Originally Posted by Louwai
I've got the 12" version of this.
The only down side that I can see is that the scope must ALWAYS be driven to position.
It does not have releasable clutches, so at no time can you "Push-To".
The scope is 100% GO-TO.
I also agree with the comments about transport. I'm lucky & am able to transport it in the trailer with my SDM. But if I didn;t have the trailer, I'd have to transport the tube in the boot & the base in the back seat laying on it's side.
Quite inconvenient.
|
Hi,
This is not the case with the 14". You can hand position it as there are encoders within the drive units. This means once you have done the initial setup, you can move it anywhere and it stays calibrated. There is no clutch.
Cheers
Rick