Quote:
Originally Posted by AlexN
With the FLI wheel, I installed FLI Filter, when you open the program it tries to connect to the wheel. If it fails, theres a drop down box to choose the port that the wheel is connected to... I'll install the software again and have a play with it to get specific details. I'll be in touch.
Cant help with the PME unless you want to post me your PME and I'll figure it out and let you know  |
That would be awesome if you could check that out. If I left click at the top of the FLI Filterwheel program you get a dropdown menu about scanning for ports. It makes no difference, it comes up with FLIfil0 and then the FLI filter wheel program works but in CCDsoft it will not connect like it does with the Proline.
Quote:
Originally Posted by Bassnut
Its a bit hard to tell from the pic, but is that a big guide cam attached via a right angle thingo waving in the breeze?. Forget that  . Good youve got the MOAG attached now  . 3m FL is a different world.
Nice rig BTW, very smick. Also, not sure, but do you have a rotator perchance?. If not, how will you rotate?. At 3m/OAG youll have some greif without one, good luck , I suspect thatl be an addition fairly shortly . |
I mounted my normal guide scope/ST402ME just to get started. I have since gotten the Lodestar to work using Direct Drive so I don't have to wait for them to supply the missing mount guide cable.
You can loosen the MMOAG and turn things around for framing. A bit inconvenient though. You may be right or perhaps something simpler like a Tak rotator. I have a million adapters I am sure one will work.
Greg.
Quote:
Originally Posted by multiweb
|
Hehe
They're not getting them back. Beats a $650 weight though!