Quote:
Originally Posted by kinetic
Is it normal for the supplied QHY dessicant heater to only JUST make contact with a typical generic 240v Aus to US adaptor as shown?
|
Yes - it's a cheap heatbox but it does the job.
Quote:
Originally Posted by kinetic
Also, from what you people have suggested, an appropriate way to
house the QHY8 in a case before and after an imaging session is as
shown below in the yellow pelical clone case?
Rubber grommet removed and dessicant heater sharing the same
removed void of foam with the camera?
thanks in advance for any advice.
Steve
|
Yes that's fine. I also remove the nosepiece and have a thin piece of mesh in front of the hole so the camera breathes. Side plug off, all the time when stored. Keep your sensor super clean. Slightest grease, finger print will ice up. It's glass you won't hurt it. Spray some alcohol on a wipe then one swipe across the length - that's all.
As Clive said I also blowdry it when assembling and that's it. No worries. Ever.
