|
A few niggling questions still people, sorry..............
Is it normal for the supplied QHY dessicant heater to only JUST
make contact with a typical generic 240v Aus to US adaptor as shown?
The slightest bump and the pins on the heater fail to make contact.
The LED goes out..with such a dodgy connection surely it's a touch
and go affair if it is even doing its job...not only that, a fire risk.
Also, from what you people have suggested, an appropriate way to
house the QHY8 in a case before and after an imaging session is as
shown below in the yellow pelical clone case?
Rubber grommet removed and dessicant heater sharing the same
removed void of foam with the camera?
thanks in advance for any advice.
Steve
|