Quote:
Originally Posted by AlexN
Do you know where to buy said white lube??
|
Here's the
Lube - SUP31040 for bearings and SUP92003 for the gears. As John pointed out no grease on clutches that's why I said only grease what you have too. Drain the bearings before putting them back and make sure the shafts are dry. The bearings just need to be "moist". Most clutch slippage is from oil from the bearing on to the shaft that transfers to the disk. The slightest drop will contaminate the whole surface because there's no big gap when they're tight and it will spread in minutes. I have actually glued mine on the bearing side both in RA and DEC with Selley's Rubber Gel Grip. So It only slides on one face. I get more break away force this way. I ran into problems when starting using the C11/Hyperstar with clutch slippage and inertia. Now it's rock solid.