Quote:
Originally Posted by pmrid
Someone in these you forums (I can't remember who I'm afraid) had a spacer made up that had a threaded male/female section in the middle, with a locking ring so that you could fine-tune the separation if you wished. Seemed like a good idea and since you're heading to the lathe anyway, this might be a good plan.
Peter
|
Yes thanks Peter, I was messing with alu stock just a few mins ago
thinking the same...but it has to also slide down the 2" focuser too
so low profile lock ring of some sort....or recessed grub screws.
cheers,
Steve