[Quark (Trevor)]

Hi All,

I am seeking advice on a problem I seem to have inserting text with CS4, to be more precise, the size of the text.

After I have finished with my planetary RGB images in CS4 I annotate them, normally using 12 font text and this always works well.
These RGB images have been previously saved as TIF's after processing and combining in Astra Image Pro.

However, when I try and add text to my IR images, that have also been saved as TIF's, following processing in Astra Image Pro, I always run into the same problem in CS4. With the text font set at 12 the text that is actually produced is more like 36 font. This is very frustrating and I get around it by annotating my IR images in PSP V8.

Exactly the same thing happens with JPG versions of my images.

I have attached an RGB and IR from my most recent session Jan 23rd. If these images are loaded into Photoshop, with the text set at 12 font and you try to add text to them you will see my problem. On the RGB the text will be the size that you set it at but with the IR the text will be very large regardless of the font setting you set.

The answer to this pretty basic question is probably quite obvious, just not to me.

Any help would be most gratefully accepted.

Regards
Trevor