View Single Post
  #128  
Old 19-01-2010, 06:37 PM
bobson (Bob)
Registered User

bobson is offline
 
Join Date: Aug 2008
Location: perth
Posts: 599
Sorry mate, I wasn't clear when I asked you a question

I have timing belts from my Canon printer, they are approx 30 cm in diam. What I need is a pulley for that timing belt. What would be the best material for it, any hints would be helpful.

This bit:

Quote:
The big wheel (or pulley) does not have to have all the teeth, only couple of them are enough (say, every 50th or 100th tooth is enough to keep sync and to prevent micro-slippage). Those teeth could be made by gluing them on the perimeter of the big pulley (appropriately dimensioned of course), using timing belt as template
thanks mate

Last edited by bobson; 19-01-2010 at 08:13 PM.
Reply With Quote