View Single Post
  #2  
Old 27-11-2009, 12:50 PM
JohnG's Avatar
JohnG (John)
Looking Down From Above

JohnG is offline
 
Join Date: Dec 2005
Location: Cootamundra, NSW
Posts: 1,711
I vaguely remember this problem coming up in the late 90's on the Losmandy Group, if I remember clearly it was to do with the drive box attachment bolt going too far into the drive box and pushing against the PCB.

I think the suggestion was at the time to put a washer on the attachment bolt and reset the PCB holding screw.

Haven't heard of this problem for years.

Cheers
Reply With Quote