Quote:
Originally Posted by allan gould
Marc
Yes, camera was run with the plug out initially after letting moisture in overnight. Chip and filter definitely iced up as camera cooling started, switch on heater and it gradually goes. Presumably sublimated ice then trapped on cold finger at the back of camera.
Fitting as follows.
1. Unscrew whole of camera nosepiece (with filter)
2. Screw heater into face of camera body
3. Screw nosepiece back into face of heater, you then have a sealed unit again.
|
So your nosepiece is higher and the spacing to the sensor changes. I'm thinking MPCC spacing. How thick is the heat ring? 7mm.
Had a chat to Theo. Mine's in the mail now
