|
David, I just had a thought.
Before you go twisting spider vanes have a good look at your avie frame by frame in registax to see if there is any up and down movement in the image. If you don't know how to do that, click and hold on the right hand side of the slider at the bottom (just like a scroll bar) and it'll scroll through all the images. What may have happened is that registax might not have lined all the images up correctly. It's simple enought to check the images and untick some from the frame list and run the prog again. If you don't know how do untick them from the frame list, use the space bar. The unticked frame will show up beside the scroll bar as a red square.
Rather that first than trying structural deformation on your vanes. If you do and accidentally stuff it up you might pop one of your own veins.
|