|
Thanks so much guys. I been reading though as much as i could here is what i gathered (may be some one can correct me because its proving to be a more difficult than what i initially expected):
When using reducer + CCD combination
-----------------------------------------
TOA-130R Reducer: required metal distance to ccd chip is 83.7mm
+ CA-35: adds 27.6mm distance
+ Wide mount T adapter: I am not quite sure about this one. I saw a few on web but none had the length spec.
+ Custom adapter if required
+ QHY8 (21mm)
When using Flattener + CCD combination
-----------------------------------------
2.7" Flattener for Takahashi TOA-130S: required metal distance to ccd chip is 117.5mm
+ CA-35 (50.8): I couldnt find any lenght spec on this yet
+ Wide mount T adapter: same ...not sure yet
+ Custom adapter if required
+ QHY8 (21mm)
|