Quote:
Originally Posted by bluescope
Lots of detail Marc. With that setup you are getting a similar fov to my FLT110 with ST2000XCM. As far as the spacing from your chip is concerned you need to know how deep inside the camera the chip is to start with and then get spacers to suit accordingly. There are various spacers/extension tubes available.

|
Thanks Steve. I measured from the sensor plane. I'm off (too far) by 1.79mm. And my chip is not completely square (+/-0.2mm) not that I think that would matter much. But I'd like to get those 2mm or so down to 0 see if it does something. Can't chop the adaptor though.