|
Nevermind about the collimate, After a few moments screwing and unscrewing, I understand now! Let me see if this is right.
1. You first check the secondary mirror through the focuser to see that it's in the center, and at the correct angle facing the you as you look through.
2. Put in laser collimator. You get the laser to go to the center of the primary mirror by lossening all 3 screws, then tightening the one that closers to where the dot is. It is essentially a tighten two screws, and losen one to put the secondary mirror at the right angle so that the dot is at the centre.
3. You adjust the knobs at the bottom to have laser enter the collimator at the exact same spot using the same method as number step 2.
Did i understand that right?
Surreal
|