View Single Post
  #7  
Old 27-11-2008, 05:32 PM
DJDD
Registered User

DJDD is offline
 
Join Date: Aug 2007
Location: Melbourne, Australia
Posts: 936
Quote:
Originally Posted by DJDD View Post

so,
-just disconnect the controller from EQ6Pro,
- plug the cigarette lighter adapter into the jumpstarter
- and the other end, that normally goes into the EQ6 mount, into the hand controller.
- flash firmware

firmware updated successfully on my synscan controller using the above procedure. I needed to set the controller to low transfer speed, as instructed in the manual.

thanks, Paul.

DJDD
Reply With Quote