Thanks for your reply, Zuts.
Quote:
Originally Posted by Zuts
3) I dont understand this. I dont have a 'DC adapter'. I just have a jump start unit and a piece of wire with a male cigarette lighter plug on one end and the DC plug on the other. I plug one end into the mount and the other into the female plug of the jump start. When i wish to power the hand-controller i just do the same.
I would not connect the hand controller while flashing the firware as if there is a glitch and the controller tries to talk to the mount while flashing you may have problems.
|
what i wondered was can i use any 12V adapter to power the hand controller on its own so that I can flash the firmware? e.g. can i use a 12V/1A adapter even though the manual says 12V/100 mA?
does your post mean that you use the jumpstart to power the controller on its own when you flash the firmware (controller disconnected fro the mount)?
Quote:
|
5) You have already answered this.
|
i felt a bit of a duffer on this one...
thanks for the reply.
DJDD