|
I made up a temperature controller device from a kit that should allow the Peltier to acheive sub zero C temperatures but was wondering should I use thinner or thicker aluminum for the cold plate toss up between 2mm and 5mm, also I was going to use nylon bolts to hold the Peltier between the cold plate and heat sink should they be OK, any feedback welcome. I don't envisage glueing a plate to the back of the CCS circuit board until sometiem after the warranty expires.
Cheers
Cheers
Last edited by TrevorW; 02-11-2008 at 07:03 PM.
|