|
Hi Robbie
Just a couple ideas to help minimize the problem:
Assuming you have the RS232 Usb adapter, have you downloaded the software for it from meade.com? (this setup gives no hassles if it's always connected to the same port)
If yes to the above, Have you used it to direct the scope with programs such as CDC, Starry nite, Stellarium or the Meade Autostar Suite?
If yes again, can you manually slew the scope using the direction controls in the telescope options in Envisage? if you can't then the problem is limited to the Envisage software
As a last thought, are you disabling the "telescope control" in Autostar before you attempt to start autoguiding with envisage,- only one program can operate telescope control at a time
If you recieved instructions for the DSI you are a lucky man, I never did!
However there is instructions in the supplement section on the supplied CD
Good luck with it all
Bryan
|