05-08-2008, 07:47 AM
|
 |
Registered User
|
|
Join Date: Aug 2007
Location: Canberra
Posts: 490
|
|
Quote:
Originally Posted by Glenhuon
These are the cables that came with my Synscan. Beige one connects between the hand controller and computer serial (RS232) port. The power cable should be connected to the hand controller too, not the motor drive box, when updating the firmware. Press 8 then 0 to enter update mode on the controller. Instructions in the book are pretty clear if you follow them exactly.
Update on mine went OK.
Cheers
Bill
|
Thanks Bill
|