[pjphilli (Peter)]

Hi
I have just spent about an hour trying to get my HEQ5PRO mount to slew.
I have followed all the setting up procedures and preset the scope at the park position. However, when I go to slew to the alignment stars the scope does not slew but gives the message "slewing complete". It does this with all the alignment stars and if I escape from alignment it will not slew to other objects or to the park position either.
I notice that sometimes on initial power on the message "start from park position" is indicated and the scope sometimes seems to operate normally if this is the case. But mostly this message is not seen and the scope does not slew.
Am I still doing something wrong with the start up? All other conditions with the scope seem normal and I am operating from a fully charged battery which was showing 12.3volts which is normal. The scope has been working properly over the past couple of nights, but I have had this problem before which only seemed to go away after many re-starts.
Cheers Peter