Quote:
Originally Posted by Roger Davis
I would suggest that you take the opportunity to make a double crosshair. Put the retaining ring/ferrule onto a piece of timber and then 4 drawing pins into a cross shape surrounding the ring. A fine gauge copper wire that you can strip from an old electronic choke can be wrapped around the drawing pins and over the ring to form a double cross hair with a square in the middle. Four dabs of epoxy, allow to set over night then trim with a sharp Stanley knife. Beats the heck out of using hydrofluoric acid on glass.
|
Hi Roger
I'm interested, but as my GS finder scope is new I'm reluctant to pull it down without first knowing more about your double cross hairs to form a square. How about showing or describing how and where these hairs are situated in the scope.
Dennis G