|
Hi Leon
Having looked at the two photos, it seems that all the fastener hardware appears to be at least from ¼ inch or 6mm stock and providing that enough turns of the thread are engaged, these look to be strong enough in my opinion.
The pins are held on either side in the casting and I suspect they are deep enough in the casting not to be able to slide out. Also, the loading on these pins would be at right angles to their long axis and it looks like Tak have made them out of thick enough stock. I suspect it would take a huge load to even flex these?
Have you had any problems?
Nice tool board!
Cheers
Dennis
|