I have redone my Peltier cooling for DSI Pro. First attempt by filing spaces between cooling fins was not very successful. It did not cool enough. This time I machined cooling fins right off used plenty of silicone heat transfer compound and installed stronger fan. I was able to cut groves in two heatsink fins and to clip fan and the small heatsink on Peltier in same way as it was originally attached to CPU.
I also received and build Temperature Control kit and it is working fine. I set the temperature on 10 Deg and with ambient at 20 Deg it reaches this temperature in about 15 minutes and it got no problem keeping it there.
If anyone will build this kit please note that there is an error on PCB overlay and in the instructions. To set it for cooling the link must be soldered to C-A not B-A as stated in the instruction
|