[Luke Bellani]

Hi All,
I have been asked to make a dovetail bar lit for a 8" LX200 Classic and I need to find the relevant demensions to make the radius bracket and dovetail bar.

I don't have access to an 8" OTA and so I'm hoping that someone here can help.

The measurements I need are as follows.

1. The overall length of the OTA.
2. The outside diameter of the OTA end castings.
3. The longitudinal centre to centre measurements of the bar mounting screw holes.
4. The radial centre to centre measurements of the screw holes at each end of the OTA.
5. The screw threads used.

Thank you very much for any help you are able to give. It is greatly appreciated.

Best regards,
Luke Bellani.