OK, updated the Program to Version 5.2.
It is finally working, but the camera isn't. Either is the screen res.
I changed over to split screens but the highest res it allows for an external monitor is still 800x600.
And the camera will not operate in the USB2 card. I managed to load it and get it working in the USB1 slot in the back, but it only took 2 frames then stopped working and a window popped up and said 'Insert device into USB2 port'.
I cannot get it to load or operate in any of the 3 USB2 ports. The icon down the bottom of screen says it's connected, but the program says it's not
