Hi Paul
I leave cables attached to my docking station and stowed as in
Fig 19 in this
article. Otherwise, my approach and evolving system is as follows:
- Coil the cables and tie them with Velcro straps.
- Always keep each Velcro strap on the cable when uncoiled and in use, so you never misplace it.
- I label each cable with a Dymo label if its identity could become uncertain due to it looking like some other similar cable.
- I clamp the DMK and ST7 cable to the mount and then to the Saddle before routing to their respective end points.
- I try not to route power and signal cables next to each other.
Cheers
Dennis