View Single Post
  #14  
Old 29-01-2007, 03:09 PM
DavidH
Registered User

DavidH is offline
 
Join Date: May 2005
Location: Mackay,Qld
Posts: 141
Hi Cristian,

Have been doing some more polishing, but the mirror appears to be returning to a figure similar to that in my post on 24/1. Have been considering doing a short stint with tool on top to see if I can get it to move to a more spherical figure. At present I don't have an image available. Will try to get one tonight. My tester is pretty much a standard Focault/Ronchi carriage with a green led for a light source. Am still unable to get more than about 3 lines outside ROC. The width of the slit image appears to be quite narrow past ROC.

Regards,
David.
Reply With Quote