Paul is this something you use regularly?
Stupid question I know and it's now late in 2024 but I had a similar issue with my lesser mount earlier 2024 when I constantly updated the date on my Synscan controller BUT forgot it was no longer 2023, simply updating the day and month. Thankfully my son caught my mistake before I got really annoyed and kicked the whole lot over in a pile (bad health, really bad temper).
I'm probably way off base so late in the year.
Did you mention you're running the latest firmware?
It may be as simple as a check to see if there is an update (I don't think there is, I have two earlier controllers and believe they are up to date and the release is not that new).
Quote:
|
The Controller is V5, almost new and updated.
|
Sorry!
Here's a manual on the controller if its of any use/help
https://www.nimax-img.de/Produktdown...leitung-EN.pdf
I did a little research and have seen mention of clearing previous alignment data before doing an alignment and also a dec axis saddle being 180 degrees out, apparently both things will cause somewhat the issue you are having.