|
I have a couple of these, very thin, diamond blades. I think they were made in Russia but I can't remember where I got them from. They are so flimsy that you need to clamp them between two metal discs. If properly clamped they can make less than 1mm wide cuts. In this case the clamping arrangement is a bit too small, to allow for deeper cuts, and the rim of the diamond disc wobbles a bit, making the cut a bit wider.
The RPM of the tool is only around 2000 as I'm driving it with a low RPM motor. The rotary table is hand driven.
Last edited by Stefan Buda; 14-09-2024 at 04:44 PM.
|