View Single Post
  #11  
Old 13-06-2024, 02:28 PM
Stefan Buda
Registered User

Stefan Buda is offline
 
Join Date: Jul 2013
Location: Melbourne, VIC
Posts: 977
Yesterday as I was about to finish the polishing of the inside surface, disaster struck! I must've got a bit overconfident and at one point I did not engage the driving pin properly. As a result, when I switched on the machine, the contraption instantly went into self destruct mode.

So, back to square one, it seems, but in fact not, because I now have most of the tooling and fixtures needed. Also I will start with a small batch so that I end up with at least two finished ones - one for a replacement spare if I ever need one.
Attached Thumbnails
Click for full-size image (Dome10.JPG)
164.0 KB96 views
Reply With Quote