View Single Post
  #9  
Old 20-08-2022, 04:43 PM
GC - South Aus's Avatar
GC - South Aus
Registered User

GC - South Aus is offline
 
Join Date: Apr 2008
Posts: 173
G'day All

G'day everyone, thanks for your replies.

I am presently away from home again for the next 3 weeks, with limited internet access.

I appreciate everyone's assistance!

Philip, thanks for your advice and offer. I actually have a a coupe of Arduino Mega's and Nano's lying around. So might look again online to see if there are any examples. If you have any links on what you did it would be greatly appreciated.

Scott, I actually have an OnStep system now. But, I only have one and plan on using the one I have with another project. Don't want to have to keep reprogramming it to use between mounts. However, a cheap $36 dollar build might be a good alternative. Thanks for the links.

PhilTas, I have already tried all the troubleshooting you have outlined, without success! But, thanks for your guidance anyway. In relation to your queries, that was just an image I saw on the internet. The grey cable hanging down is just for an added ST4 guiding port (DIY). So the close up image is exactly what I have, minus the extra ST4 (DIY) wiring (just standard HC).

Thanks all.

Regards

Gav